I am using a Linkys WRT54G v3 router with OpenWRT v10.03.1. My end goal is to use Traffic Control (tc) and Network Emulator (netem) on the router, which are in the ip package (this is the iproute2 package in most linux distributions).However, my computer is connected to a work network, and the router is connected to my computer via an ethernet cable.

OpenWrtNVRAM - OpenWrt To route via a router, use: @OpenWrt:/# nvram set static_route=10.1.2.0:255.255.255.0:192.168.1.1:1:vlan1 This will use vlan1 to send packets to 10.1.2.0 via router 192.168.1.1 . As of the most recent CVS build, all values must be present. The networking script doesn't detect missing values, and will thererfore not create the route if the How to Configure OpenWRT Wifi Router WISP / AP+Client Mode The below are the steps to follow make OpenWrt router WISP Mode Configuration.Before the starting of the configuration your laptop/PC must have same series of IP address in LAN properties. And then start configuration.For configuration open the browser in your laptop and type 192.168.1.1

KuWfi WE826-4G For USA/CA OpenWRT Wireless Router 3G 4G

May 04, 2018 #3356 (add static routes support) – OpenWrt

Trouble with static routing : openwrt

OpenWrt Project: Routing Routing. Routing is the process of selecting paths in a network along which to send network traffic. There are a couple of Routing protocol s to make this happen more or less automatically. For this, we are going to use static routing. The routing is handled by a component of the Kernel and can be configured by the user space tool ip which is contained in the package iproute2. Trouble with static routing : openwrt My main router (Router A) runs OpenWRT and is connected to the internet and serves IP address in the 192.168.1.x range to my main network. I have connected a Raspberry Pi running OpenWRT to this via wifi (static IP 192.168.1.254) (I'll call this Router B). I have set … Static Routes not working : openwrt - reddit I had created a static route within LUCI and either it just isn't working, or openwrt has really weird static route configurations. I specified the interface to be the same interface of the 172.16.0.0 network. I specified the target of 192.168.0.0, netmask 255.255.255.0. And the gateway of 172.16.0.5. Static Route difficulties : openwrt - reddit